|
Post by Mastercaster on Aug 22, 2012 7:15:48 GMT -8
I have another batch of silicone coming. I decided to make a new silicone dispenser. This time I will elevate the side of the bucket that the silicone pours out of so that once flat on the stand again the floor will tilt to the hole. I found a piece of 3/4" PVC pipe that fit perfectly inside the 1" brass nipple that is screwed into the flange on the buckets underside. I did decide to put a smaller diameter pipe under it. I poured in about 1200 Grams of silicone.
|
|