|
|
Post by my80malibu on Sept 21, 2012 20:57:11 GMT -8
Greg, I have mastered some wheels, and would like to ask if Primering them, will affect the molding process.
|
|
|
|
Post by Mastercaster on Sept 21, 2012 22:03:09 GMT -8
Hi Gabe. It should not effect the mold making process. Whatever you give me will be what you get plus a little flash if they are open spokes in the wheel.
|
|
PHXKSTM
Junior Member
Joey
Posts: 83
|
Post by PHXKSTM on Oct 4, 2012 17:57:56 GMT -8
Spokes? I'm curious what kinda spokes?
|
|
|
|
Post by Mastercaster on Oct 4, 2012 18:41:32 GMT -8
Well....I suppose they may not be defined as spokes but I don't suppose that you would call it a fence post either. I'm speaking about a wheel that would have an open area like most any Cragar wheel. My above post might be confusing since I spoke the word spoke. There would be some flash or a thin bit of resin where the open area of the wheel is formed. I hope this clears up spokes since I have spoken.
I copied some deep dish Cragars for Brad. I will post a pick when I get time.
|
|
|
|
Post by my80malibu on Oct 4, 2012 20:25:36 GMT -8
I am making some masters of five spoke Crager wheels for the 66 Nova Combining the centers from the, 65 AMT El Camino to the wheels of the nova. And another set of wheels, using the centers from the AMT 62 Impala Torq Thrust wheels with the nova wheel set. Basically cutting and pasting.
|
|
|
|
Post by Mastercaster on Oct 5, 2012 10:20:48 GMT -8
|
|
|
|
Post by my80malibu on Oct 5, 2012 22:32:32 GMT -8
|
|
|
|
Post by my80malibu on Nov 17, 2012 22:13:37 GMT -8
Hey Greg I left the wheels at Bernies. After seeing you had forgotten them.
|
|
|
|
Post by Mastercaster on Nov 18, 2012 1:48:17 GMT -8
Yes, It sucks! It's a long drive to get them picked up. I HATE IT WHEN I FORGET TO REMEMBER!
|
|
|
|
Post by gasser59 on Nov 18, 2012 11:49:58 GMT -8
I recognize those rims Greg. Thanks for the castings. Much appreciated.
|
|
