clear resin parts with color tint

[Mastercaster]

Here is a small bottle of HOK Gold Kandy Dye. I mix it with side "B" of the resin.



First I squirt a little on a paper towel to hopefully not have any dried flecks fall in the resin.





I put in three drops and stirred well.



The color was not rich enough, so I added two more drops.



I only poured in enough to fill up the mold cells to make the part to not overfill. The result was of course much less flash. I'm still experimenting too.



I have a pair of tweezers that are sharp at the end. I pull the flash away from the part carefully, then remove the part.


Here are some parts I made using testors Gloss Enamel STOP LIGHT RED. I put this in the pot this morning and pulled them out about 6PM today and then I mixed up some clear resin using Testors Enamel SIGNAL AMBER.